anyone using this product will be blown away , 20x to 50x longer lasting than anything they have ever seen

www.toughguard.com

no lie, no joke

What kind of protectant should I use on the top of a 2009 Mazada Miata?

Does anyone know the factory size carbon brush for the Cyclo?


Thanks,
ASAP Auto Detailing

I need help I recently purchased a 1994 GJC, and changed the oil, fixed rear brake wires, replaced muffler and changed plugs and wires. When I inspected the plugs they were white like new, which I have looked up and everything pointed towards fuel mixture running lean. I get horrible gas mileage and passed inspection after replacing the muffler and right front tire. I don't want to dumb too much money on it, being I use it as a daily driver 2nd car. But the poor gas millage is killing me. Oh it has a straight 6 4.0 liter engine, someone please help me......................

1993 cavalier z24 3.1 isn't getting a spark. Can you tell me what the problem is? Checked fuses. No power starting from the coil pack.

My truck cranks good and runs good but sometimes after you are going down the road it start to run bad as if you have a gas problem or ingition problems. You can pull over and the engine is not missing and running fine while idleing or if you give gas. If you turn engine off and crank again it will run ok again a little while longer. I changed WIRES,PLUGS.FUEL PUMP,FUEL FILTER. STILL SAME PROBLEM.

i have just replaced the engin control module, the inigintion coil, the rotator and distrobetor along with all the spack plug wires but am still not getting fire where should i look to fix the problem

When I got home from work today our 1993 Silverado would not shut off as in the ignition switch would not turn. I turned it to the start position for an instant while it was running then I was able to turn it off. Now when I try to start it the gauge lights come on but the engine does not turn over. I'm guessing ignition switch. Anyone else have any ideas? I sure could use your thoughts.

Thanks in advance.

I have a 1999 dodge caravan and the pait is oxidized very bad what can I do to bring it back. Besides painting. Thnaks

My taurus runs extremely rough at idle and sometimes stalls. OBD test indicates a fuel problem. but as the rpm's drop the brakes get hard as if they were losing vacum. Could this be an actual fuel system problem or could a vacum leak cause the other sensors to read it as a fuel problem?

My 2000 Jeep Cherokee 4.0 6 will not charge. I replaced the alternator and battery and the engine would turn over but would not start. I sprayed starter fluid in it and started just fine, but you have to spray starter fluid every time to get it to start. It still is not charging.

i just replaced a trans mission on a 94 jeep qrand cheerokee and after starting it. it runs horrible, i was thinking do the tork converter have to be installed a certain way dut to a sensor reading the converter?

Hi. I recently purchased a 1993 Chev. Cavalier Z24 Convertible and have discovered that it has a slow transmission leak. I've checked all other fluids and they seem fine. I checked the transmission fluid level and need to add some but am unable to see where to add the fluid. Can someone tell me where to fill the transmission fluid for the '93 Cavalier Z24? Thanks. Les

I recently inherited a 1999 Toyota Corolla LE, and neither the owner's manual nor the dipstick gives instructions on checking the transmission fluid. So I checked it while hot and in PARK, after running it through P-R-N-D-1-2 and back again. It showed WAY over full on the dipstick. I am not sure whether my mother unintentionally over-filled it, or I am improperly checking the level. Does anyone know how to properly check the transmission(transaxle?) fluid level in this vehicle? Thanks.

my 90 chevy pickup some times cuts out going down the road bucks and kicks and goes on for a couple of days and does it again could it be the fuel pump going out i have put new fuel filter on it but done it today it acts like it is runnig out of gas

I have a 1996 jeep cherokee country 4.0L i6 for some reason it seems not to be charging I have had the altinator checked and it is good and I am being told that the computer is starting to go out I just need some advise on what to do and how long to wait and where to find a good used or new one.

My cherokee dies, when making a turn and does the same when I hit a bump in road at higher speeds. I have never run across anything like this before. If anybody has any ideas please respond. Thanks

i have a 2000 jeep cherokee laredo, & replaced brake switch, but if i put fuse in breaker my brake lights stay on all the time & wont go off until u pull fuse? without fuse in i dont have any break lights. i have searched the net, but im not finding any answers. lights,directionals & all work, the only problem im experiencing brake lights any help would be greatly appreciated

HELP!!!! i have a '96 grand cherokee, 4wd, 4.0 straight six. it'll start and run fine for awhile. all of a sudden it will shut down and will only restart after it sits. sometimes 10min. sometimes hrs. i've ohmed out every sensor i can find, checked fuses, pulled out some hairs. when you turn the key on, all lights illuminate as they should. there is fuel in the rail. it acts as if there is no spark. i put my test leads in the connector to the coil and when you turn the key on, there seems to be momentary power at that point, then the asd relay kicks out. is that normal? if not, what could be causing it? i'm at a loss. i'm starting to think the puter. give me some ideas what to look for.

thank you.
jim kemp
cleve, ohio

O.K. two years ago i had the fuel pump replaced, then the entire front-end. last month the alternator, battery. now the blazer starts hard. Low fuel pressure (45psi or less when not starting) so starts after about 15 min. off turning over. BUT if i put the on the battery charger on boost it starts right up first try. SO question is if the battery is not the right one for the blazer with enough cranking amps will this send low voltage to the fuel pump cousing the low fuel pressure at start up?